Hello everyone! I am posting again because I received excellent help from my last post.
I am trying to finish a sealed enclosure that was built by a friend of mine. The details are as follows:
--Sealed box for 2 Pioneer 12s.
--Volume dimensions fit within required range for those
specific subs.
--3/4" MDF all around, double thick front panel
--2 1/2" Screws every 3"
--Abundance of wood glue on every seam/connection
--Appropriate/Adequate internal bracing
--Looks like clear silicone caulk along all seams
--Fully carpeted
--Single Wire terminal
The box is built like a vault. Heavy, sturdy, and sealed all around. I did a smoke check on all external seals and the box is airtight. The only issue I have is with the internal divider that separates the box into 2 identical chambers, 1 for each sub. This divider has a solid seal top, bottom, and back. However, on the front edge where the divider meets the inside of the front panel, there is a small gap. It has been filled with glue and sealant but the seal is not airtight. With both subs installed, I can press on the left sub and the right sub slightly moves. I know the leak is from the forward seal of the divider. Since the box is basically complete, it is impossible for me replace the divider panel with a better fitting one. Also, due to the amount of glue used, the sealant, and the internal bracing, I can't get close enough to the connection to add a filler block to complete the seal.
So here is my question: If I leave it alone with that leak between each chamber, and use it the way it is, will that damage the subs? Keep in mind the full external seal is fantastic and free of any leaks. The only leak is internal, between the 2 chambers. I'm afraid to connect everything and use it as is because I have no idea if that leak between the 2 sub's chambers will cause damage or blow one of the speakers.
Please help...! I need to get this finished and installed so I can have room on my work bench to work on one of my many other projects.
Any and all help is greatly appreciated!
Thank you in advance!