Sold my Audi A4 Avant last week, and while sad to see it go, it has gone to a great new home and it was time for something different, but the same, enter another white wagon, only this time in the shape of a 2015 Volvo V60 T6 R-Design. It's AWD with a 325HP turbocharged inline 6, only slightly heavier than my A4 was, it's a rocket, driving home from picking it up I had to constantly be careful of my speed as it was all too easy to be at 80+ Couple pictures of the car:
I already debadged it, other visual changes are going to be tinted windows and lower it about half an inch or so. I don't want it as low as my A4 was, but want it lower than the stock height it currently sits at.
It came stock with the "Volvo High Performance" system, which is 3 way in the front doors, 2 in the rear and a center (I read somewhere that it is a 12 speaker set up, but I cannot figure out the 12th speaker as it has no factory sub). Eventually that will all be replaced with the below, and a Stereo Integrity SQL12 (not pictured):
So today, I decided to remove the door card to take a look at what I will be starting with. The tweeter in the sail panel just pops off, but it looks like the tweeter is somewhat sealed into the housing. In the picture below you can see the cross hatch pattern where it looks like the 2 halves were melted together. Since I don't want to demolish this, looks like I need to order some new tweeter housings:
The factory midrange is screwed to the doorcard on a little plastic mount, hopefully as long as there is enough depth (99% sure there is) then I can simply make my own mounting plate and install the 20MX in this location:
The midbass is mounted to the door itself, but located directly beneath the mid. Looks like plenty of depth to mount the TM65's so no major concerns there:
Here's where things get a little confusing, at least for me. So, the molex plug boot is in a sort of Z shape, getting 3 sets of wire through is going to be a massive headache. I had hoped to tap into the stock speaker wiring, I don't run huge amounts of power, so the stock wire should be fine for me and I will just splice my own wire into it inside the kick panel. But, at the moment I cannot figure out how it's wired (not yet pulled the molex plug, hoping I can get lucky). So, here is the wiring for the tweeter and mid:
The wires are the exact same color, even the plugs are identical. Here's the wiring going to the midbass:
4 wires, no clue why. I am going to try to find some wiring diagrams, hopefully that sheds some light on things and ideally I can use existing wire through the molex. I cannot stand trying to fish wires into the doors, so am hoping for some luck. Once I get that figured, I will deaden the outer skin as much as I can and then the inner skin (the drivers door rattles like crazy).
Last picture is a quick measurement with REW of the stock system, all the EQ is flat (has a 5 band in the head unit). In all honesty, it does not sound that bad other than the complete lack of anything below 35Hz.
Over the next couple weeks I am hoping to pick up power cable and deadener and then start getting things installed. Make sure to follow to see all my screw ups!!