-
05-24-2020
#1
Junior Member
amp problems
so i finished my build, I have two 4 ohm Sa v.2 down to 1ohm wired to a banda 3000.1 my amp will go into protect mode when I hit loud volumes when i play downloaded music off my phone but when I play music off of youtube i can push it a lot harder, im kinda of confused, any one have any ideas, I grounded it to the body of the trunk and my power wire is hooked to the battery. tomorrow morning im going to test the ground.
-
05-24-2020
#2
Banned
Re: amp problems
romajiro,
Your amp is maybe ? Getting stresses from maximum current draw [ turn volume down ]
-
05-24-2020
#3
Junior Member
Re: amp problems
so I checked the ground it was good, but my battery will drop below 12v when it hits hard, so im going to do the big 3 upgrade and get a better battery next week or so.
-
05-24-2020
#4
Re: amp problems
Different music sources have different loudness levels. Guessing this is more of an SPL setup.
Mazda CX5 AF GB10, AF GB25, AF GB60, JL VX800/8i, AF GB12 sealed, Mmats M1400.1
Ford F150 AF GB10, AF GB25, JLC5, JL twk88/Pioneer D8604, Mosconi Pico, JBL Club 5501, Sundown SD3-10 ported @ 30 Hz
Sienna AF GB15, Audiofrog GS690, JL twk88/Pioneer D9500F, JBL GTX500, Alpine SWS10 ported @ 31 Hz
https://www.diymobileaudio.com/threa.../#post-5608901
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Back To Top