Try adjusting the values in the lower right corner in the filter tasks section?
Or, you could share your REW save file an let someone tinker with it to see what they can find?
Measure with mics, mark with chalk, cut with torch, grind to fit, sand to finish, paint to match.
Updated Justin tuning sheet (Justin and Erica tuning companion for SMAART and REW)
Do it for them.
I have played with all kinds of different values. Sometimes a measurement works and sometimes it doesn't.
There has to be something simple that I am doing wrong.
I just tried to auto eq sub signal and it worked fine this time. I don't understand what the heck is going on.
Here are the measurements:
I have this error sometimes as well. When changing from 1/48 smoothing to 1/24 smoothing this error dissappears for whatever reason.
SYNC3 headunit
Mosconi Pico 8/10 DSP
Mosconi D2 500.1
Gladen Zero Pro 165.3 DC
JL Audio 10w3v3 in custom enclosure (Blueprint by Mark @Caraudiofabrication)
I downloaded your measurements and had no issues...
here is the auto eq for the "left" measurement.
and here is the "right"
If you are working on only one driver, or some part of the curve other than the whole curve, you should use "Speaker Driver" as the target type and enter the HP and LP crossover points you desire, which should be the same ones you entered in Jazzi's spreadsheet to create the curves.
I found that if I save the measurements, close the app, and re-open it works fine.
I will try changing from 1/48 to 1/24 smoothing to see if that makes it work too.